DVMs Water HP

Water Cooling

The DVM S WATER is a cooling & heating system for buildings that uses water as its heat source, with connections to cooling towers and boilers. Using a highly efﬁcient compressor and heat exchanger, it provides a reliable performance that’s unaffected by changes in the surrounding environment.

Dual Inverter Compr

The DVM S WATER air conditioning system saves money and the environment, while providing a powerful performance. Its innovative Dual Inverter Compressor, with a high efﬁciency Vapor Injection System, ensures powerful, rapid cooling and heating using minimum energy, so it’s very eco- friendly.

*Tested on AM300KXWANR*** compared with Samsung conventional model AM300KXVAGH***

Flexible Installati

The DVM S WATER can be installed almost anywhere, regardless of its location or
distance from the building. It has a maximum piping length of up to 170 meters (558ft) between the outdoor and indoor units, while still ensuring complete reliability. Also reach up to a height of 50 meters (164ft).

*Max height and length may vary by combination of IDU and ODU

Lower Installation Costs

The DVM S WATER is much more economical to install as it has a small footprint and lightweight design, but a large
30 horsepower(HP) capacity. So instead of installing two 10/20HP units you only need one 30HP unit, using 41% less
space and reducing the costs of valves, ﬁttings and gauges.

Independently Cool & Heat

With the DVM S WATER’s optional MCU* you can independently cool and heat different spaces at the same time. Instead of just heating or cooling everywhere, with the MCU each indoor unit can be operated separately, so you can simultaneously heat some areas of the building, while cooling others.

Built-in Water Flow

The DVM S WATER’s built-in Water Flow Controller helps control the amount of water used to cool and heat the outdoor unit. It determines the optimum ﬂow of water based on the internal temperature of the spaces, so the circulation pump’s energy consumption is optimized and costs reduced.

Louver-less install

The DVM S WATER is louver-less installation ensuring that the outside of your building stays neat&tidy. Because it’s cooled with water, there’s no need to install unsightly louver to allow air to circulate and remove excess heat, thus no impact on the integrity of its architectural design.

Minimal noise level

The DVM S WATER has a low noise level, so it
won’t impact on your building’s environment or disturb anyone at work. In particular, because it uses a water-cooled Plate Heat Exchanger, there’s no noise caused by the fan of an outdoor unit.

* Tested on AM300KXWANR*** compared with Samsung
conventional model AM300KXVAGH***
* Sound Pressure level is a relative value, depending on the distance
and acoustic environment.
* Sound Power Level Measured according to ISO 3741.